Hakko Electronics FR-811, Instruction Manual

Page: 11 / 48

10
※In the top screen, tilting the control knob up or down switches between the handpiece
section and bottom heater section of the display screen.
Note:
Switching cannot be performed while changing a setting.
T C P
T C B
- - -
º
F
- - -
º
F
300
º
F
050
%
M A N U
T O P
100
S
T I M E A I R
0 0
OPENED
T O P B T M
1. Menu screen (P.11) 4. Timer
setting (P.12)
6. Airflow setting (P.12)
2. Temperature
setting (P.12)
3. Offset
temperature
setting (P.12)
5. Timer mode
selection (P.12)
M A N U
T C
T C P
T C B
- - -
º
F
- - -
º
F
BTM
300
º
F
R A M P
- -
º
F ／ S
L
* The mode can be set to T/C mode in which the
temperature of the circuit board is measured using a
thermocouple or POWER mode in which output power
is controlled.
** When POWER mode is selected, the setting becomes
the output power.
*** When T/C mode is selected, the startup rate can be set.
※When pressing the S button (on the station) on the display screen of the bottom heater, bottom
heater works / stop. (
refer to the “
●
Connection method of the bottom heater” in page 42.)
●
Initial Value
Air
50 ％
Set Temp
600 ℉
Timer
- - -
RAMP
- -
Timer mode
Opened
T O P B T M
In the top screen, the cursor can be moved to the items for which settings can be changed by
turning the control knob to the left or right. The items which can be set are as follows:
B. MANUAL mode settings
Note:
When an item is selected, if no
control is performed for
approximately 3 seconds, the
display will return to the normal
screen.
・
Bottom heater display screen
Menu screen
Mode
selection*
Temperature setting
(output power setting**)
Startup rate
setting***