8
6. Operation
(cont'd)
External output
The terminal block for external output is located on the left side of the body. Pass/Fail results can be
output from this terminal.
The following shows the output circuit. Output can be enabled by either "PASS" or "FAIL" according to
the DIP switch settings.
As external output is photocoupler output, add a drive circuit when a large current is required for
connection of a relay or other device.
1
2
3
FG-465 side
+
terminal
-
terminal
Output time: ON for 1 second after evaluation
Photocoupler output
Max. absolute rating DC 80 V
Max. output current DC 5 mA
DIP switch No.6
OFF: External output on PASS
ON: External output on FAIL
No.1, 2
For external
output
No.3
For GND
Terminal block for external output (conditions of use)
Model
XW4C-03E1-H1 (made by OMRON)
Stripped length of lead
10 mm
Applicable lead
Single wire
0.2 mm
2
— 4.0 mm
2
Strand wire
0.2 mm
2
— 2.5 mm
2
Rod
terminal
w/o sleeve
0.25 mm
2
— 2.5 mm
2
w/ sleeve
0.25 mm
2
— 1.5 mm
2
AWG
24 — 12
Connection to terminal block
Example: When directly connecting lead
(1) Use a lead of size that falls under the applicable lead
category.
(2) Strip back 10 mm of the sheath from the end of the lead,
and twist the end.
10 mm
CAUTION
A correct connection is no longer possible if the end of the
lead is pre-soldered.
(3) Push in a screwdriver or similar tool into the release hole
on the terminal block. (a)
(a)
(b)
Terminal insertion
hole
Release hole
(4) Insert the lead with sheath stripped back from its end
into the terminal insertion hole. (b)
When removing the lead, push a screwdriver or similar
tool into the release hole, and draw out the lead.
