32
HAKKI PILKE RAVEN 33
TRANSLATION
VERSION 1
5.
Remove the old belt.
6.
Insert the new belt from the side of
the in-feed conveyor's drive roller
through opening B (Figure 32), until
you can pull the belt out from other
end C (Figure 33). Note! If necessary,
remove the guard of the in-feed con-
veyor in accordance with the instruc-
tions in Section 4.5.
Figure 32.
7.
Lead the rest of the belt under the log
press, around the rear roller and, final-
ly, behind the conveyor.
8.
Connect the joint by inserting pin A
(Figure 31) into the joint.
Figure 33.
9.
Turn the conveyor back to the operat-
ing position and tighten the belt. Use
adjustment nuts D (Figure 34) to adjust
the belt.
The belt is at the correct tension when
its middle section is raised approx. 5 cm
when the conveyor is in the operating
position. An excessively tight belt may
be damaged more easily, and it places
unnecessary strain on the conveyor
bearings.
Figure 34.