Hakki Pilke HakkiFeed 472, Manual

Page: 10 / 14

10 / 14
Hakki Feed 472 Translation Version 1
Washing and cleaning
Loose debris and sawdust can be cleaned from the machine with pressurised air, for example. The machine
can also be washed with a high-pressure washer as long as the water jet is not aimed directly at the bearings.
Always ensure that the machine and the working area are sufficiently clean during operation. The machine
must always be cleaned after use. Clean the machine at suitable intervals and always before storing the
machine for a prolonged time. After washing, the machine must be lubricated according to the instructions in
Section
5.2 .
6. Storage
Although the machine is intended for outdoor use, it should be covered and stored in a sheltered location or
indoors. Before prolonged storage, the machine must first be cleaned, then washed according to Section 5.8
and lubricated according to Section 5.5.
7. Maintenance table
Target Task Daily Interval
100 h
Interval
500 h
Substance/access
ory item
Lubrication points Lubrication ( Section
5.2 )
Lubrication
grease/oil
Chains (condition,
tightness) Check X
Hoses Check X
8. Failures and remedial measures
Failure Cause Remedial measure
The chain conveyor chains are
not running or are sluggish
1. The chains are too tight or
loose
2. Log stuck crosswise
3. Chains must be greased
4. Quick coupling fault or
loose coupling
5. Incorrect valve pressure 1. Check chain tension
( Section 5.1 )
2. Remove and replace
3. Grease chains
4. Repair connection
5. Contact the retailer
The in-feed conveyor rollers
are not rotating. 1. The feed serial connection
valve is connected to the
machine
2. Quick coupling fault or
loose coupling
3. Log stuck 1. Open the valve
2. Repair connection
3. Disconnect
from the
power source and remove
blockage