61
down, so that the adjustable legs hit the end of the open groove in the feet fas
-
teners (Figure 2.4.-5.). If the appliance is operated without leg fastener, it may tip
over. In this case, the manufacturer assumes no liability for possible damages.
Figure 2.4.-2.
Figure 2.4.-1.
Figure 2.4.-3.
Figure 2.4.-4.
Figure 2.4.-5.
d) The selected location must be ready to host the discharge opening for conden
-
sate water connected to the upper part of the appliance with corrugated pipe.
e) Please, make sure that the location of operation, and the electric and hydraulic sys
-
tems to be connected to the appliance fully comply with all relevant regulations.
f) The selected location must be equipped (or must be suitable for being equipped)
with a single phase 230 V ~ 50 Hz external mains switch.
g) According to the definitions of the relevant regulations, the selected location has
to comply with IP protection class (ingress protection rating) of the appliance.
h) Do not expose the appliance to direct sunlight through any window even.
i) The appliance may not be exposed to effects of especially aggressive agents, such
as acidic vapours, environment saturated with dust or gases.
j) The appliance may not be directly connected to a mains supply network without
overvoltage protection.
k) The appliance must be placed and operated as close to the withdrawal locations
as possible, in order to limit the diffusion of heat along the pipeline.
l) Proper electrical, water and sewage network (floor sink) connections must be en
-
sured at the installation location.
m) To decrease heat loss attributable to the hot water pipe, the appliance should
be installed the closest possible to the hot water withdrawal locations. In case of
longer distances, the hot water pipe should be added heat insulation.
Summary of Contents for HP-TOWER HPT200
Page 140: ...140 HPT 200 HPT 200C ...
Page 141: ...141 ...
Page 142: ...142 HPT 200 HPT 200C Jegyzetek Notes Notes ...
Page 143: ...143 Jegyzetek Notes Notes ...
