EN
PROFESSIONAL CORDLESS CLIPPERS
15
1.5.
Safety instructions
Electrical hazards
Make sure that the power supply voltage
shown on the nameplate (Fig. 2) of the
clippers corresponds to that of your
electrical installation.
To provide additional protection, it is
recommended to install a rated residual
differential current device (RDD) not
exceeding 30 mA in the electrical circuit
supplying the equipment. Request
advice from your installer.
Regularly check the condition of the
electrical lead. If the lead shows any
signs of damage, stop using the
equipment immediately. Contact the
dealer or his after-sales service to obtain
a replacement lead.
In the event of failure of the charge stand
or power pack, it must be replaced by a
model that is identical in all respects.
The electrical lead must always be fully
unrolled before it is connected to a
power socket.
