PROFESSIONAL CORDLESS CLIPPERS
EN
22
3.
Use
3.1.
Charging the battery
It is essential to charge the battery for about 2 hours before using the clippers
for the first time. Charge the clippers at least once during the year following
the date of delivery. The battery reaches its full capacity after 3 or 4 charging
cycles.
USE ONLY THE POWER PACK SUPPLIED, MODEL BI12TA-050200-AdV (Fig. 1-K).
When charging, it is advisable to switch the clippers off (On/Off button set
to 0, Fig. 1-B).
Insert the electrical lead into the socket of the clippers (Fig. 3a).
Connect the power pack (Fig. 1-K) to a mains power socket.
When completely charged, the clippers can be used without the electrical lead.
3.2.
Operation
When first used, lubricate the blades by applying a drop of oil to the points
shown (Fig. 5).
3.2.1.
Switching on/off
Switch the clippers on by pressing the On/Off switch (Fig. 1-B).
To stop the clippers, press the On/Off switch again (Fig. 1-B).
When the clippers are not in use, it is advisable to clip the cutter cover (Fig. 1-N)
onto the blades.
3.2.2.
Use with or without electrical lead
With a new, fully charged battery, the clippers can be used without the power
lead for about 150 minutes.
Charge the battery of the clippers before the end of the autonomy period, refer
to § 3.1.
The clippers can be used with the power lead. To do so, connect the cable to the
clippers (Fig. 3a) and connect the power pack (Fig. 1-K) to a mains power socket.
3.3.
Adjusting the cutting height with the lever
The cutting height can be adjusted during use of the clippers, with the adjusting lever
(Fig. 1-C):
Push the lever upwards to reduce the cutting height.
Push the lever downwards to increase the cutting height.
