EN
25
3.1.2.
Charging the clippers on the charger base
Insert the electrical lead into the charger base socket (Fig. 2b).
Insert the power pack in a mains power socket.
Put the clippers on the charger base (Fig. 1-K).
At the end of charging, the indicator light comes on steadily. The clippers can
then be used without the electrical lead.
3.2.
OPERATION
When first used, lubricate the cutters by applying a drop of oil to the points
shown (Fig. 4).
3.2.1.
Switching on/off
Switch the clippers on by pressing the On/Off button (Fig. 1-B). The button
lights up.
To stop the clippers, press the On/Off button again (Fig. 1-B). The button goes
out.
When the clippers are not in use, it is advisable to clip the blade cover (Fig. 1-
O) onto the blade.
3.2.2.
Use with or without electrical lead
With a new, fully charged battery, the clippers can be used without the power
lead for about 120 minutes.
Before the end of the autonomy period, the charge light flashes.
Charge the battery, refer to § 3.1.
The clippers can be used with the electrical lead. For this, connect the cable to
the clippers (Fig. 2a) and connect the power pack (Fig. 1-L) to a mains power
socket.
