Hainbuch ms dock, Operating Instructions Manual

Page: 46 / 72

ms dock
Use
46 Order h49 7144.907-333
8.4 Checking the total stroke
WARNING
Serious crushing injuries caused by moving parts
when stroke positions are being tested!

Set the machine into set-up mode.
 Never reach into moving parts.

Pay attention to the gap dimensions of moving
parts.
Prior to commissioning, check the complete stroke to ensure
that there is sufficient reserve stroke and opening stroke.
For this, the same measurement of the moving part must be
performed at fixed points in front and rear limit positions.
Then deduct the value obtained in the rear limit position from
the value obtained from the front limit position. This figure
must then be equal to or greater than the nominal total
stroke.
For the axial nominal total stroke, the values of axial clamp-
ing reserve and axial release stroke must be added together
[see »General information« chapter].
8.5 Tests
NOTE
Serious damage to, or destruction of, the machine
tool and the workpiece caused by damaged, in-
complete or incorrectly installed products!

Only install undamaged and complete products
properly.
 If in doubt, contact the manufacturer.
Assure the following points before every installation and/or
before every time the products are put into service:

The products used are undamaged.

All fixing screws are present on the products, and are
tightened to the correct tightening torque.

None of the edges and races are chipped or show any
signs of wear.

The speed set on the machine tool must not exceed the
maximum speed of the product [
𝑛 = 0
on stationary
products]. Always take the lowest value of all maximum
speeds for combined products indicated.

Do not exceed the maximum actuating force indicated
on
the product.
Always take the lowest value of all actuating forces indi-
cated for combined products.

All installation tools are removed from the machining
area.