<10cm
<1.5m
5
> 30mm
The drainage shall be smooth with the drain hose.
1.
The height of the drain hose shall be less than
10cm, or the drainage will not be smooth, and
cost such long time that the machine may stop
at mid way.
2.
Do not step on or press the drain hose.
4.
If extra drain hose is needed, please make
separate purchase. The inner diameter of the
extra hose shall not less than 30mm, and the
length shall not exceed 1.5m.
3.
If the drain hose is too long, cut it at mid point.
To make smooth drainage, cut the front end of
the hose slantingly.
Usage the drain hose
5.If the extra hose is too long, cut it either at A
or at B.
The largest allowable slope of the shank base of the machine is 2 .The slanting or rough ground will result in
unstable running or stoppage of the machine. Please adjust it with following methods:
Confirm it's horizontal:
Hang the lead line to check if it is
horizontal.
Adjust the adjustable leg:
Fasten
Loosen
High
Low
the adjustable nut
the adjustable leg
1 .To twist the adjustable leg, please first lift up the
side of the leg slightly, loosen the adjustable nut,
and twist the leg.
2 . After adjustment, fasten the nut.
Adjust the Installation position
1.Push "POWER" button to switch on the power
2.Push "PROGRAM/" button to select suitable full-auto program
Steps of using the operation buttons and description of the
steps
After the power is switched on, "MEMORY" is automatically set. To select other full-auto program, please push
the "PROGRAM" button till the corresponding indicator is on. Refer to the "PROGRAM" button on Page 10.
E.g. Set to "QUICK"program for small quantity of laundries with light soil.
When a standard cycle is selected, the fuzzy program is run. The water level and the washing time can be
selected according to be texture and volume of the laundry. The washing cycle is automatically controlled.
I DELAY
"+ - "
button
Push down the
select the reserve time(2h-24h),
Push the
button can display the reserve state.
"+ - "
"+ - "
SOAK
then push
SET
"+ - "
For the MEMORY,BLANKET,CHILD,STANDARD programs push the SOAK
botton
select the desired soak time( 0,10, 20,30,40 minutes)
For cotton program, press
SET
button can change the process
,can not change time
"SOAK"button
then press
"+ - "
J "SOAK " button
K Reserve, remain time digitron
It displays "--" during detecting.
It displays remained reserve time (hour).
It displays abnormal symbol in abnormal situation.(See to Page15)
You can choose "RESERVE WATER" function to keep the after rinsing water.
Washing machine will keep the after rinsing water once finish rinsing in tub about 4 hours, and buzzer every 15
minutes.( For example, if you choose "SECOND RINSE", the machine only keep the after second rinsing water,
if you choose "FIRST RINSE" and "SECOND RINSE" together, the machine will keep the after first and second
rinsing water)
Press"START/PAUSE" button or open and close the top lid one time to collect the after rinsing water, then the
machine will go on for next program.
If you don't collect the after rinsing water within 4 hours, the machine will drain automaticly, then go on for
next program.
L
"
RESERVE WATER
" button
M
SET
"+ - "
button
Refer to the description of operation button
12
RESERVE
WATER
