20
X. The outer case becomes live.
Possible causes
1. Whether the electric circuit is good.
2.The washer is not safely earthed.
3. The damaged rubber sheath of the power cord results in electric leakage.
Troubleshooting
1. Check whether the insulation of power cord is good. If not, make necessary
replacement.
2. Earth the washer safely.
3.Check the condition of the rubber sheath of the power cord and wrap the damaged
parts with insulation tape.
XI .The door lock indicator does not light.
Possible causes
1. The door lock indicator is broken.
2. The wiring of micro delay switch is loose.
3. The indicator loses.
Troubleshooting
1. Replace the broken indicator.
2. Tighten the stub of micro delay switch.
3. Refasten the indicator.
XII. No function or malfunction of program controller
Possible causes
1. The motor of the program controller fails or the stub is sealing-off.
2. The knob of program controller is stuck.
3. Poor contact of the wiring of the program controller.
4. Poor contact in at the inner contacts of program controller (even after all the plug
wires are tightened.)
Troubleshooting
1. Reassemble the motor of program controller and make a spot welding of the stubs
(the operation of program controller and motor can be heard after the appliance is
turned on.)
2. Adjust the position of knob of the program controller.
3. Tighten the stubs of the program controller one by one.
4. Replace the program controller with a new one.
