18
V. The drum doesn't rotate; the spin speed is too high or too
low.
Possible causes
1.The belt tension is too low or the fastening bolts are loose.
2.The plug wire of motor is loose or the motor is broken.
3.The capacitor is broken.
4.The electronic module is broken or is not properly plugged.
Troubleshooting
1.Adjust the tension of belt and tighten the screws.
2.Check whether the plug wire of motor is loose or whether the motor works
normally, if not make the necessary replacements.
3.Check whether the capacitor is good with a universal meter. If not, make
necessary replacement.
4.Replace the electronic module with a new one.
VI .The water level is too high.
Possible causes
1. Gas leakage at the pressure system of the water supply.
2. The pressure switch is broken.
Troubleshooting
1. Check whether the pipeline of the pressure system is blocked or there is a gas
leakage. The pressure system includes:
(1) Gas-collecting valve
(2) Rubber pipe
(3) Pipe clip
2. Blow on the pressure switch and a "click, click" sound can be heard. Otherwise,
replace the pressure switch with a new one.
VII. No heating or automatic heating
Possible causes
1. Thermostat breakdown
2. Effect of ambient temperature
3. The water-heating pipe is broken.
Troubleshooting
1. Check whether the knob of temperature controller clicks at room temperature. If
not, make necessary replacement.
Note:
1). The temperature controller breaks down when it is cold and no click can be
heard. Warm the room and the temperature controller will get normal.
