![background image](http://html.mh-extra.com/html/haier/lc-2710d/lc-2710d_operating-instructions-manual_138179005.webp)
7
PREPARATION FOR REMOTE CONTROL
3
2
1
+
+
Remote control installation
1. According to the figure display below, place the remote control with face down,
then open the cover of battery apartment.
2. As in the figure display below, install two AA batteries. (The + and - symbol of
battery must match with the marks on the remote).
3.Close the cover of battery apartment.
Cautions for using remote control
Confirm there is no object between the
remote control and the remote sensor
of TV set.
Sunshine or other strong light will
interfere the signal sent by the remote
control. In this situation turn the TV
set to avoid the direct light source.
Do not put the remote control in direct
heat or a damp place, or potential
damage to the remote may occur.
Please use two AA 1.5V batteries.
Do not mix battery types.
Install the batteries as the correct
polarities.
Do not use the rechargeable batteries.
6
BASE DISASSEMBLY METHOD AND PREPARATION FOR WALL MOUNT BRACKET
(1) In order not to scratch the TV set, it is recommended putting the TV set
with the face down on the soft and clean blanket.
(2)Disassemble the six screws from base and remove the base.
(3)Mount the airproof board as figure.
(4)Take out the switching support from accessory bag, and use four M5
×
16
screws(included in the accessory bag) to fix the switching support on the
back of complete set.
Note
1. The arrow indicates the position of screw.
2. The remaining four M5
×
16 screws in the accessory bag are used to mount the
wall mount parts.(replace the four M4
×
20 screws in the packing carton of wall
mount bracket.)
3. This operation is only used before mounting the bracket.
4. Wall mount bracket is sold separately.
Base
Switching support
Switching support
Airproof board
Summary of Contents for LC-2710D
Page 3: ......