25
USING YOUR TV AS A COMPUTER DISPLAY
VG A-A U DIO IN
VGA
VGA input
1. Connect the VGA output port in the computer to the VGA port in the TV set.
2. Connect the audio cable in computer to VGA AUDIO IN port in TV set.
3. Press TV/AV button to select VGA mode.
4. Turning on the computer, the screen image of the computer will display on the
TV set.
At this time, the TV set can be used as a computer display.
Note:
1. If the temperature of the TV set is rather low, it is normal that there may be some
artifacts when the set is first turned on.
2. Nonconforming pixels may occur on the panel, but they have no influence on the
normal function of the display.
3. In the standard operation, it is normal if there is one bright dot or dark dot on the
screen.
VGA
SVGA
XGA
640
x
480
800
x
600
1024
x
768
31.5kHz
37.9kHz
48.4kHz
60Hz
60Hz
60Hz
Mode
Resolution
Horizontal
Frequency
Vertical
Frequency
RESOLUTION:
Note: The above parameters are VESA standard.
A NT .
VCR
AUD IO IN
L
R
S-VI DEO
IN
DVD
DVD
L
R
AU DI O IN
Y Cb/Pb Cr/Pr
INPUT
OUTPUT
A UD IO
(
L
/
MONO
)
AU D I O
(R)
S
-
VIDEO
VIDEO
SCART1
SCART2
You can connect outside signal source VCR, VCD
DVD, PC equipment to the TV set.
Antenna Input
1.Connect the VCR radio frequency input to
the back radio frequency input of the LCD.
2. Connect the antenna to VCR antenna input.
3. Press TV/AV button to select TV mode.
4. Press PLAY button in VCR to start watching.
S-VIDEO input
If you use S terminal as signal input source, the
image quality will be better than video (AV).
1.Connect S terminal output in DVD to S terminal
input in TV set.
2.Connect S terminal left/right audio output in DVD to
the relevant port in TV set.
3.Press TV/AV button repeatedly until the display
mode is S-VIDEO.
4.Press PLAY button in DVD to broadcast. At this time
the image programs in DVD will broadcast in TV set.
YPbPr input
1. Component terminal (Y/PbCb/PrCr) connect to the
component output of picture output device (such as
DVD, TUNER and so on ), the sound is input
from AUDIO IN:
2.Press TV/AV button to select YPbPr mode.
3.Press PLAY button on the external device to start
watching.
SCART input
1.Connect AUDIO OUT in the VCD/DVD to the
AUDIO/VIDEO port in the SCART commutator
in the accessory.
2.Connect the SCART commutator in the accessory
to the SCART1 or SCART2 in the TV set.
3.When SCART commutator select INPUT, it enter
video input status, when SCART commutator
select OUTPUT, it enter video output status.
4.Press TV/AV button to select SCART1 or SCART2
mode.
5.Press PLAY button in VCD/DVD to start watching.
Note: please never use the S terminal in commutator.
24
EXTERNAL AUDIO AND VIDEO EQUIPMENT CONNECTION