13
Disposal after washing
Please
fi
rst pull off the power plug from the receptacle before cleaning.
After using, please clean the lint and foreign materials of the lint
fi
lter and
over
fl
ow
fi
lter in time. Otherwise it may in
fl
uence your using the machine.
Clean the detergent box with water.
The method of dismantle and installation refer to the
usage of dismantle and in stallation lint filter.
Install
Dismantle
5.Wipe off the water drops on the surface of the machine and inside the tub. Open the top lid
for some time (about 1 hour), then close the top lid.
2.Do not store water in the washing machine for a long period. Drain the water completely
after each using.
The filter screen of the
water inlet valve is likely
to be blocked by foreign
materials and influence the water inlet.
Please clean it with brush every two
months.
If the cabinet is dirty, wipe it with
wet cloth
Do not flush it directly with water.
Wipe it with neutral detergent.
Do not wipe it with thinner, petrol, alcohol etc.
1.After washing, close the water faucet. ( If needed, you can dismantle the water inlet hose).
4.Hang up the power cord and drain hose.
3.Be sure to pull off the power plug before maintenance.
Detergent box
The lint filter must be used during washing.
It must be cleaned in time after each using.
The methods of dismantle
and install lint filter 1 as follows:
The methods of dismantle and install lint filter 2
as follows:
1.Push down the spring piece
of the top lint filter to make the
claws out of the filter cover,and
then pull out the lint filter to get
it down(figure 1).
2.Pull the back cover of the lint
filter, and then you can get
down it off the front cover
(figure 2)of the lint the lint filter.
3.Sweep the rubbish in the lint
filter.
4.Put the back cover of the lint
filter into the front cover .
(figure 2)
5.Put the lint filter into filter
cover, and make it tight.
1.Pinch the flexible film on the top of lint filter
(detergent box) and pull it out. Remove the spindle
at the bottom of the lint filter from the
shape
of the filter cover along the direction of the arrow
diagram (arrow up for ). Remove the other side of
the spindle directly from the filter cover slot then
can remove the lint filter.
2.Pinch the left and right sides of the horizontal
bars on the top of the back cover of lint filter, rotate
along the assembly axis of the front cover of the lint
filter and the bottom of back cover of the lint filter,
open the back cover of lint filter(figure 3) .
3.Sweep the rubbish in the lint filter.
4.Rotate the back cover of lint filter along the assembly
axis and clamp on the lint filter former cover (figure 3).
5.Insert one bottom side spindle of the lint filter into the
corresponding shape install slot at the filter cover
bottom. Then clamp the other side spindle into the
shape at the filter cover along the arrow in the picture
(arrow down for install).At last pinch the horizontal bars
on the top of the lint filter and clamp it into the filter cover.
The top
The lint filter 2
The filter cover
The lint
filter 1
The front cover
of the lint filter
the front cover of the lint filter
The back cover of lint filter
The bottom
the bottom
dismantle
Filter cover
Figure 1
Figure 2
Figure 3
Make sure the lint filter is well installed, or it can influence your use.
dismantle
dismantle
install
install
groove
groove
groove
