Haier HW90-B14636, User Manual, Page: 24 / 100

9-Troubleshooting
GB
24
-
●
ance, disconnect the power supply and contact the customer service.
9.4 In case of power failure
●
The current programme and its setting will be saved.
●
When power supply is restored operation will be re-
sumed.
In case of power failure during programme run door
opening is mechanically blocked. If the laundry is to
●
be removed, the water level must not be visible in the
Lower the water level according to step 1 to 6 of
●
door is unlocked by a gentle click.
A 9-1
Note: Foam formation
If too much foam is inspected during spin cycle, motor stops and drain pump will be ac-
tivated for 90 seconds. If that elimination of foam fails up to 3 times, programme ends
without spinning.
Cause
drum and/or deter-
gent drawer.
Detergent is not a appropriate. Check detergent recommen-
dations.
Excessive use of detergent. Reduce amount of detergent.
Automatic adjust-
ment of washing
time. Washing programme duration will
be adjusted. This is normal and doesn‘t af-
fect functionality.
Spinning fails. Check machine load and laun-
dry and run a spinning pro-
gramme again
.
-
ing result.
Degree of pollution does not agree
with selected programme. Select an other programme.
Detergent quantitiy was not suf- Choose the detergent accord-
ing to the degree of pollution
and according to manufacturer
Maximum load has been exceeded. Reduce loading.
Laundry was unevenly distributed
in the drum. Loose the laundry.
Washing powder
residues are on the
laundry. Insoluble particles of detergent can
remain as white spots on the laun-
dry. Perform extra rinse.
Try to brush the points from the
dry laundry.
Choose an other detergent.
Laundry has grey
patches. Caused by fats such as oils, creams
or ointments. Pretreat the laundry with a spe-
cial cleaner.