Haier HW80-B1239N, User Manual

Page: 23 / 68

EN
9-Troubleshooting
23
F1*9/,3 Cause $*/:'&*+
'2
• Temperature sensor - error.. • Contact the After sales service..
'.
• Heating error • Contact the After sales service..
'8
• Motor - error.. • Contact the After sales service..
'9
• Water level sensor - error • Contact the After sales service..
':+
or
':3%
or
%
':-
• Abnormal communication error • Contact the After sales service..
;!<
• I).353)2"<$5(3<$-$"!!(!88 • Check and balance laundry load in the drum.
F1*9/,3 Cause $*/:'&*+
Washing machine fails
to operate. • Programme is not yet started. • Check programme and start it.
• Door is not properly closed. • Close the door properly.
• Machine has not been switched on. • Switch the machine on.
• Power failure. • Check power supply.
• Child lock is activated. • Deactivate child lock.
Washing machine
0155$)(%$."$;55"<$01%&$
water.
• No water. • Check water tap.
• Inlet hose is kinked. • Check inlet hose.
• D)5"%$&(#"$;5%"!$1#$.5(2X"<8 • I).5(2X$1)5"%$&(#"$;5%"!8$
• Water pressure is less than 0.03 MPa. • Check water pressure.
• Door is not properly closed. • Close the door properly.
• Water supply failure. • Ensure the water supply.
Machine is draining
0&15"$."1)7$;55"<8
• Height of drain hose is below 80 cm. • Make sure that drain hose is
properly installed.
• Drain hose end could reach into
water.
• Make sure the drain hose is not
in water.
Drainage failure. • Drain hose is blocked. • I).5(2X$<!31)$&(#"8
• /@4$;5%"!$1#$.5(2X"<8 • G5"3)$4/@4$;5%"!8
• Drain hose end is higher than 100 cm
3.(Q"$6((!$5"Q"58
• Make sure that drain hose is
properly installed.
Strong vibration while
spinning. • Not all transportation bolts have
been removed.
• Remove all transportation bolts.
• Appliance has no solid position. • Ensure solid ground and a levelled
position.
• Machine load is not correct. • Check load weight and balance.
Operation stops
before completing
wash cycle. • Water or electric failure. • Check power and water supply.
Operation stops for
a period of time. • Appliance displays error code. • Consider display codes.
• Problem due to load pattern. • Reduce or adjust load.
• Programme performs soaking cycle. • Cancel programme and restart.
G!5#I1*:9/,A)**'&+2#%&')*:'#8&A./->#(*8,