SERVICE MANUAL
Model: HRF328\368
10
Issue 2015-7-18
Rev.
Ref 1507S002V1
Chapter 3 Installation, adjustments and maintenance
3-1. Unpacking
1. Remove all packaging material; this includes the foam base and all adhesive tape holding the
refrigerator accessories inside and outside.
2. Inspect and remove any remains of packing, tape or printed materials before powering on the
refrigerator.
3-2. Adjusting
1. The refrigerator is designed for freestanding installation only. It should not be recessed or built-in.
2. Place the refrigerator on a floor strong enough to support it fully loaded.
3. When moving refrigerator, never tilt it more than a 45-degree angle. This could damage the
compressor and the sealed system.
4. If refrigerator is tilted let it stand in an upright position for at least 24 hours prior to plugging. This is
to allow the refrigerant to settle.
5.Proper Air Circulation
To assure the refrigerator works at the maximum efficiency it was designed for, you should install it in a
location where there is proper air circulation, Plumbing and electrical connections.
The following are recommended clearances around the refrigerator:
Sides…………..2”(50mm)
Top. ……………2”(50mm)
Back…………..2”(50mm)
Do not over fill refrigerator for proper internal air circulation.
3-3.Electrical Requirement
Make sure there is a suitable power Outlet with proper grounding to power the refrigerator.
Avoid the use of cutting off the third grounding, this is a dangerous practice since it provides no
effective grounding for the refrigerator and may result in shock hazard.
3-4. Operating
See 4-1. Control and display panel
