�
If the supply cord is damaged, it must be replaced by the manufacturer, it service
agent or similar qualified person in order to avoiding a hazard.
�
Warning-----Do not damage the refrigerant circuit
�
Warning-----Do not use electrical appliances inside the food storage compartment of
appliance, unless they are of the type recommended by the manufacturer.
MAINTENANCE
MAINTENANCE
MAINTENANCE
MAINTENANCE
�
Remove power plug or disconnect from the mains before performing any
maintenance or servicing the product.
�
Never use detergent or chemicals harmful to health to clean the water tanks.
�
Do not directly spray water on the surface of the product.
�
Wipe the front and back of the product with water-soaked soft cloth.
�
If dust of other exterior substance has accumulated on the condenser, wipe off with
water-soaked soft cloth.
�
After cleaning the product, completely dry it. Fill the water to the tanks until waters
comes out of the hot water faucet, then connect the electric power plug. If the
surface of the electric heater in the hot water tank is deposited by water deposition,
heating capacity will decrease. Fill hot water tank with aqueous solution of 2% aitric
acid and keep for about two hours then cleaning. If the problems can not be solved,
contact your dealer or the Service Center of our company.
�
If power supply cord on this device is damaged, it must be replaced with a special
power supply cord that is obtainable at Service Center of our company.
TROUBLESHOOTING
TROUBLESHOOTING
TROUBLESHOOTING
TROUBLESHOOTING GUIDE
GUIDE
GUIDE
GUIDE
You can solve many common water dispenser problems easily, saving you the cost of a
possible service call. Try the suggestions outlined below to see if you can solve them
before calling the service center.
Problem
Possible Reason
Water dispenser does not operate.
Not plugged in.
The circuit breaker tripped or blown fuse.
Water dispenser is not cold enough.
Check to be sure the cold switch on the back is
turned on.
The water dispenser does not have the correct
clearance.
Water dispenser’s hot water is not hot
enough.
Check to be sure the hot switch on the back is
turned on.
Compressor
turns
on
and
off
frequently.
The room temperature is hotter than normal.
The water dispenser does not have enough
backside space.
Vibration
Check to assure that the water cooler is placed
level.
Water dispenser makes too much
noise.
As each cycle ends, you may hear gurgling
sound caused by the flow of refrigerant, which is
normal.
Contraction and expansion of the inside walls
may cause popping and cracking noises.
The water dispenser is not placed level.
