Haier HAIH6IESCE, User Manual

Page: 46 / 156

44
Using the extractor fan
The extraction system can be used in two versions: external
extraction and evacuation or as a filter with internal recirculation.
Extraction version
Fig. 4.b
The fumes are evacuated towards the outside through a series of
pipes (bought separately) fastened to the supplied connecting
flange.
The diameter of the exhaust pipe must be equivalent to the
diameter of the connecting ring:
- for rectangular outlets 222 x 89 mm
- for circular outlets Ø 150 mm (*)
For more information, see the page relative to the extraction
version in the illustrated part of this manual. Connect the product to
wall-mounted exhaust pipes and holes with a diameter equivalent
to the air outlet (connecting flange).
Using wall-mounted exhaust pipes and holes with a smaller
diameter may reduce the efficiency of extraction and drastically
increase noise levels.
All responsibility in this regard is therefore denied.
Keep duct as short as possible.
Use ducting with the least possible number of curves
(maximum angle: 90°).
Avoid drastic changes in the ducting diameter.
Filtration version
Fig. 4.a
The extracted air will be filtered in special grease filters and odour
filters before being sent back into the room. For more information,
see the page relating to accessories in the installation manual -
Filter version.
Warning: If the outlet is inside the cabinet, create an air vent
through the plinth panel measuring at least 120cm
2
.