3
English
FAN ASSEMBLY
1. Position the rear guard over the motor shaft, ensuring that the notches are
correctly aligned and then secure with the locking nut.
2. Align the fan blade with the flat part on the motor shaft, locate fully and secure
by tightening the fan blade screw fully.
3. With the help of another person, position the front guard against the rear grill
and push the guard ring in place so that it holds both guards together and the
screw is at the bottom. Secure by tightening screw.
STAND ASSEMBLY
1. Slide the cover plate up the shaft and attach the flange of outer tube to the base
using the nuts and bolts provided. Check nuts are fully tightened before
replacing the cover plate.
2. Unscrew the height adjustment knob, and pull up the inner tube to adjust the
height, ensuring that the knob is fully tightened before proceeding.
3. Position the fan head motor either side as shown in fig 2 and insert the tilt control
bolt so that it passes through the square hole of the coupling and the lower hole
of inner tube. Fully tighten the small screw that is already located in the coupling
and then fit the knob onto the tilt control bolt and lightly tighten.
1. FRONT GUARD
2. SCREW
3. GUARD RING
4. FAN BLADE
5. LOCKING NUT
6. REAR GUARD
7. FAN BLADE SCREW
8. MOTOR SHAFT
9. SPEED CONTROL
10. FAN MOTOR
11. MAINS LEAD
12. KNOB
13. INNER TUBE
14. HEIGHT ADJUSTMENT
SCREW
15. OUTER TUBE
16. BASE SCREW
17. COVER PLATE
18. BASE
19. FLAT WASHER
20. SPRING WASHER
21. NUT
Fig 2
