1
2
3
Remove the battery cover;
Load the batteries as illustrated. 2 R-03
batteries,resetting key(cylinder); Be sure
that the loading is in line with the " + "/"-";
Load the battery,then put on the cover
again.
Loading of the battery
Hint:
Clock set
Operation
The distance between the signal transmission head and the
receiver hole should be within 7m without any obstacle as well.
When electronic-started type fluorescent lamp or change-over
so the distance to the indoor unit should be shorter.
wireless telephone is installed in the type fluorescent lamp or
room, the receiver is apt to be disturbed in receivingthe signals,
Note:
Press CLOCK button,
"AM" or "PM" flashes.
SMART
1
2
3
Confirm time.
press CONFIRM,"AM "and
"PM" stop flashing,while
clock starts working.
PM
AM
When the remote controller
appears abnormal,use a
Used to select CODE A or B
with a press, A or B will be
displayed on LCD.Please
25.HEALTH button
28.FRESH button
29.SLEEP button
33.CLOCK button
30.TIMER ON / OFF button
31.HOUR button
32.CANCEL/CONFIRM
34.LOCK button
18.CODE button
Inquire the external
environmental temperature
the machine. (e.g. when the
panel display “01”, the
operating power is 100W;
when the panel display “02”,
the operating power is
200W, and so forth)
This function unavailable on this models.
Inner side of the controller
26.SWING UP/DOWN
27.SWING LEFT/RIGHT
button
22.POWER / SOFT button
21.LIGHT button
20.INQUIRE button
19.RESET button
If pressed, the other buttons
24.HEALTH AIRFLOW
sharp pointed article to
press this button to reset
Used to confirm timer and
will be disabled. Press it once
again,lock will be cancelled.
select A without special
SMART
FAN
COOL
SMART
HEAT
DRY
CTD
SET TEMP. ROOM TEMP.
AUTO
AUTO
AUTO
FAN
SPEED
POWER
SOFT
iFP
ECO
TIMER ON OFF
PM
AM
19
20
21
22
23
24
25
27
28
29
30
31
32
33
34
18
23.10
26
the controller normal.
and the operating power of
button
button
button
clock settings.
explanation.
Full display or unclear display during operation indicates the
batteries have been used up.Please change batteries.
If the remote controller can’t run normally during operation,
please remove the batteries and reload several minutes later.
Remove the batteries in case unit won’t be in usage for a
long period.If there are any display after taking-out,just need
to press reset key.
After time setting is confirmed,
Each press will increase or
decrease 1min.If the button
is kept pressed,time will
change quickly.
Press “+” or “-” to set
correct time.
special heating set function:
10 degree heating maintaining
(valuable for RS)
Control the lightening and
extinguishing of the indoor
LED display board.
The manual of how to change
the default display temp
：
Press LIGHT button
continuously for ten times, the
display temp on display panel
can be changed between
ambient temp and set temp.
2
All manuals and user guides at all-guides.com
