Haier 2U14CS4ERA, Service Manual

Page: 59 / 96

. .9 Overheat Protection For Discharge Temperature
Outdoor display: LED1 flash 8 times
The Discharge temperature control is checked with the temperature being detected
by the Discharge pipe thermistor
when the compressor discharge temperature is above 110
ć
■
Electronic expansion valve defective
■
Faulty thermistor
■
Faulty PCB
* Caution Be sure to turn off power switch before connect or disconnect connector, or
else parts damage may be occurred.
Electrify the machine again and turn it on with the remote controller,
then measure the temperature at the exhaust temperature sensor of
the compressor on the outdoor unit
The temperature exceeds
110
ć
shortly after the
machine starts up?
1) The cryogen may have been leaked during
installation, or there may be leakage in the piping
system.
2) There may be other causes to make the exhaust
temperature too high.
Malfunctions occur after running for some time even
though the measured temperature is below 110
ć
. Pull
out the exhaust sensor and measure its resistance at
standard temperatures according to the
resistance-temperature table
The results deviate
much?
The sensor is damaged. Replace the sensor
with a new one.
The outdoor mainboard is damaged and needs be
replaced
YES
NO
NO
YES
Service diagnosis
Domestic air conditioner
Conditions
Supposed
Causes
Troubleshooting
Method of
malfunction detection
Malfunction detection
conditions