Connect each wire to the terminal strip on the thermostat base per the
wiring diagram for your system application - See Figures 4 - 8.
Form the thermostat wiring so that the cable lies flat between the
terminal strip and the center of the thermostat base - See Figure 2.
Figure 2 -
Forming thermostat wiring
If a remote system is being used with the thermostat, connect the
remote system wiring to the supplied cable using the wire splices per
the diagram for your remote system application - See Figures 9 - 10.
Insert the cable into the connector on the thermostat circuit board
marked "COMM".
Upon completion of wiring the thermostat, push all excess wiring
into the hole in the wall. Plug the hole with the supplied insulating
foam to ensure an accurate temperature reading by the thermostat.
4
