4
D
Do
o
1. Comply with all local building, plumbing, and electrical codes.
2. Install before the water heater.
3. Install after the pressure tank on well-water installations.
4. Install a pressure-reducing valve if the inlet pressure exceeds 90 psi (6.2 bar).
5. Install a gravity drain on the cabinet.
6. Secure the drain line on the appliance and at the drain outlet. See
Installation Steps and Start-Up
Procedures.
7. Allow a minimum of 8 to 10 feet (2.4 to 3.1 metres) of 3/4-inch pipe from the outlet of the appliance to the
inlet of the water heater.
D
Do
o N
No
ott
1. Do not install if checklist items are not satisfactory. See
Checklist Before Installation.
2. Do not install if the incoming or outlet piping water temperature exceeds 120°F (49°C). See
Specifications.
3. Do not allow soldering torch heat to be transferred to valve components or plastic parts.
4. Do not over tighten the plastic fittings.
5. Do not plumb the appliance against a wall that would prohibit access to plumbing. See
Installation Steps
and Start-Up Procedures.
6. Do not install the appliance backward. Follow the arrows on the inlet and outlet. See
Installation Steps and
Start-Up Procedures.
7. Do not plug the transformer into an outlet that is activated by an on/off switch.
8. Do not connect the drain and the overflow (gravity drain) together. See
Installation Steps and Start-Up
Procedures.
9. Do not use to treat water that is microbiologically unsafe or of unknown quality without adequate
disinfection before or after the system.
Note:
A bacteriostasis claim does not mean that these devices will make microbiologically unsafe water safe to
consume or use.
P
Prre
ec
ca
au
uttiio
on
nss
Summary of Contents for Maximizer 400
Page 39: ...37 N No ot te es s...