16
S
Se
ettttiin
ng
g a
an
nd
d U
Ussiin
ng
g tth
he
e C
Co
on
nttrro
olllle
err
In addition to the (R) Button, the controller has the following buttons that are used when programming Service
Settings and Customer Settings.
C
C B
Bu
utttto
on
n
The C, S, P, and
(Scroll Back) buttons are used when changing Customer Settings and Service Settings.
The C button is used with the S button to set the value of certain parameters.
1. When you press the C button, the value under the cursor changes to the next available value,
typically increasing by one until all values have been displayed and the process begins again.
S
S B
Bu
utttto
on
n
The S button is used to move the cursor when setting parameters.
1. Press and release the S button to move the cursor one digit to the right of the parameter to be changed.
2. When the cursor is at the extreme right position, press the S button again to reset the cursor to the extreme
left position.
P
P B
Bu
utttto
on
n
The P button is used to enter programming modes and also to save a value and display the next value to be
changed.
1.
To program Customer Settings,
press and hold the P button for about 5 five seconds while
“CUSTOMER SETTING” is displayed.
2.
To program Service Settings,
press and hold both the P button and the S button while
“SERVICE SETTING” is displayed.
3.
To reset the factory defaults,
press and hold both the P button and the
(scroll back) button for about five
seconds.
((S
Sc
crro
ollll B
Ba
ac
ck
k)) B
Bu
utttto
on
n
The
button function is used to step back to a previous parameter setting. It is typically used to go back to correct
a setting without the need to scroll forward through all settings.
Summary of Contents for Maximizer 400
Page 39: ...37 N No ot te es s...
