User Manual
Version: 1.2
DP II
Revised: 2015-03-16 15:47
8
| © Haglöf Sweden AB 2013/Rev. 201503
DP Radio Button
The DP Radio Enter button can
replace the mechanical enter
button on the caliper movable
handle. The radio button is used
when the DP terminal and
SmartScale are used stand-alone
The Radio Enter button is fac-
tory assembled on the DP II caliper.
Changing the Battery
The battery in the DP Radio button will last for approx-
imately one year depending on use. The DP Radio uses a
CR2032 3V battery. To change the battery, follow these
instructions.
1.
Unscrew the screw (Torx T10) that attaches the DP
Radio button on the handle.
2.
Remove the DP Radio button from the handle. Re-
move the battery lid by pulling it straight up. Remove
the battery.
3.
Replace the old battery with a new battery. – inside, +
toward battery lid. Press the lid into position.
4.
Attach the DP Radio on the handle with the screw.
Always dispose of old batteries in special battery containers
Synchronizing the DP Radio Enter Button
The DP Radio is synchronized with the computer terminal.
When assembling a new DP Radio Button, the synchroni-
zation needs to be made as follows:
1.
Disassemble the DP Radio Button and battery accor-
ding to point 1 and 2 above.
2.
Press 5-6 times on the DP Radio Button to drain it
completely.
3.
Assemble the battery with – to the inside and + to the
battery lid.
4.
Press the battery lid in place.
5.
Start menu ”Radio” in the computer terminal. S
ystem
menu—Settings—Radio—SYNC.BUTTON
”.
6.
When the menu is running, press one (1) time on the
DP Radio Button and the message Press
DPRadio
button
is shown.
7.
Repeat point 1-6 if the procedure failed.
8.
Assemble the DP Radio Button on the handle with
the screw.
Turn off/on the DP Radio Function
The Radio function in the computer terminal can be turned
off when the DP Radio Button is not in use to save battery.
1.
Select ”
System menu—Settings—Radio—Enter
OFF
” and press ENTER to turn off the function.
2.
The Menu text will change to: ”
System menu—Set-
tings—Radio—Enter ON
”.
