6/64
CMp
| Safety instructions
Bosch Rexroth AB, RE 15409 Version 08.2022,
2 Safety instructions
2.1 About this chapter
This product has been manufactured in strict compliance with the generally
accepted rules of technology. However, this does not exclude the risk of damage
to persons or property if this chapter and the safety instructions included in the
present documentation are not observed.
f
Read the entire documentation carefully before starting to use the product.
f
Keep this documentation in a location where it is accessible to all users at any
time.
f
When passing over the product to third parties, make sure to include the
necessary documentation.
2.2 Intended use
The S-Link Monitoring Unit allows data capture from hydraulic applications and
transmits this data for remote condition monitoring.
In the application the S-Link Monitoring Unit is classified as a component in terms
of the Low Voltage Directive (LVD) 2006/95/EC. The S-Link Monitoring Unit is
exclusively intended for integration in a machine or system or for assembly with
other components to form a machine or system. The S-Link Monitoring Unit
may only be commissioned after it has been installed in the machine/system for
which it is intended and the safety of the entire system has been established in
accordance with the LVD.
The product is intended for professional and not for private use.
Intended use includes having read and understood the entire documentation, in
particular the “Safety instructions” chapter.
The product is intended for the following use:
•
Measuring, collection and transmission of drive data from a hydraulic
controlsystem for remote monitoring.
Observe the technical data, application, operating conditions and performance
limits as specified in the product-specific data sheet and in the order confirmation.
2.3 Improper use
Any use of the product not in accordance with the above definition is improper and
thus inadmissible.
Inadequate products installed or used for safety-relevant applications may produce
unintended operating behavior and result in product or property damage. For
this reason, use a product in safety-relevant applications only on condition that
such use is specified and allowed in the corresponding product documentation.
For instance in a potentially explosive atmosphere or in safety related parts of a
control system (functional safety).
