Page 19
For internal use only
Assembly Instructions CB 280
A61
Rotate the cylinder block 360 degrees. The axial run
out between the bearing and the connection block
must not exceed 0.03 mm. If the axial run out is not
obtained, loosen the screws and make the adjustment
once again from A52.
A62
The drawing shows the correct position of the seal.
A64
Install the radial lip seal into the seal retainer and tap
it down with a plastic hammer. Turn the seal correctly
according to drawing A62.
A63
Grease the tool.
Place the radial lip seal
on the tool D-40063.
Note!
Check so that the tool is free from damages
to avoid to distroy the sealing.
!
!
See Service information No. 15
