Hagerman Technology FryBaby, Manual

Page: 6 / 13

FryBaby Kit Manual 6
Mount the 3.5mm dc power jack into the center hole on front plate. Textured side
faces outward.
Mount the two RCA jack to the other holes. Orient as shown and tighten.
Front plate assembly.
Insert the battery terminal clips into the bottom half of case.
Insert the plastic LED dome lens into the top half of case. Secure in place with the
black plastic ring.
Circuit Board
Assemble the circuit board in the following order. Use the stuffing guide in the back of
this manual. Solder and clip leads before continuing.
Install all resistors, diodes, and axial leaded capacitors.
Install integrated circuits.
Install transistors.
Install LED. Short lead towards rotary switch.
Install electrolytic capacitors.
Install rotary select switch. Make sure it is inserted fully and is flush with board.
Integration
Mount circuit board into bottom plastic using the four supplied #4 screws.
Solder short lengths (about ¾”) of bus wire into the holes at the front edge of the
circuit board. They are labeled OUT and DC.
Solder short wires into the 9V and unlabeled ground hole (next to it) at the bottom of
the board.
Solder the 9V wire to the “+” battery terminal on the case (nearest).
Solder the ground wire to the “-“ battery terminal.