102
To programme a detector as a relay:
1.
Press Cfg1. After 4 s, the red LED flashes.
Keep holding the button down
.
2.
After 10 s, the flashing speeds up or slows down:
- if the flashing speeds up
, the relay function has been
activated
,
- if the flashing slows down
, the relay function is still
deactivated
.
3.
Release the button and press briefly on Cfg1 to exit the programming mode.
2.6. Putting a detector back into its factory configuration
Upon the back into factory configuration, the interconnection between the detectors
will be deleted.
1.
Press 2 times on the Cfg1 key.The red LED flashes.
2.
Keep holding on the Cfg1 key until the red LED light up steadily. Release the button.
3.
Briefly press Cfg1 to exit the programming mode.
• It is possible to programme just one “relay” detector per network.
• To be programmed as a relay, the detector must first have been
programmed for recognition by the network.
Summary of Contents for TG551A 3
Page 111: ...111 ...
