GB
27
3. Lightly press on the Cfg1 key on all
of the detectors
to exit recognition
programming mode.
Cfg1
Cfg2
4.
Test the radio range.
A.
Put
all the detectors in test mode by pressing once on the Cfg1 button
.
The red LED lights up for 5 sec and then flashes.
B.
Press
the test button on one of the detectors
and the detector will test
the radio range in permanent transmission mode. The red LED on all the
detectors lights up steadily.
C.
Position the detectors in their planned locations without fixing them in place.
• If the radio range is satisfactory, the red LED remains steadily lit.
• If the radio range is not satisfactory, the red LED flashes.
D.
Move the detectors located outside of the radio range or programme one
detector as a relay (see 2.4 Installing the detector as a relay) then perform
the test again.
E.
To exit the test mode, press once on the Cfg1 button on all the detectors.
The red LED goes out.
F. Perform the radio range test for all the detectors
again to make sure they
trigger, whatever the detector having activated the alarm.
5.
Fix the detectors in place following steps 1 to 4 in chapter 2.2 Installing a
detector as a standalone device.
