30
Installing several detectors in a network
It is possible to inter-connect up to 40 detectors to make alarm activation possible over the
whole range of smoke detectors of the home.
1. After the detector’s mounting base has been nstalled, unfasten the connector block.
2. Then do the wiring as follows:
Connect only detectors of the same model within the network.
To install TG501 detectors in a network, an asymmetric power supply can be used.
A separate cutout should be used for protection in this case.
3. Fasten the connector block back onto the supporting base.
4. Lock the detector on its base.
TG 501A
TG 500A / TG 500B
For a cable of 1.5 mm csa, the distance shall not exceed 400 m.
Summary of Contents for TG 500A/AL
Page 51: ...51...
