1-1/8"
(29mm)
1-3/4"
(44mm)
1-1/8"
(29mm)
3/4"
(19mm)
A
B
2
1
FRAME
RIGHT HAND DOOR
90˚ RIGHT ANGLE
Fast
Slow
2
1
1. PARTS
3. INSTALL CLOSER
2. MARK AND DRILL HOLES (
Right Hand Shown)
4. INSTALL MAIN ARM
5. INSTALL MAIN ARM AND
CONNECTING ROD
6. ADJUSTMENTS
7. INSTALL PINION CAP
PINION CAP
Select hand of door and degree of door opening. Fold template
on the corresponding line for desired degree of door opening
and hand. Match this line with the hinge edge and door and
attach template to door. Be sure frame line on template lines up
with the bottom edge of frame face. Mark, prep and drill/tap 1/4"
- 20 holes for closer body and jamb shoe mounting screws.
Remove template and use mounting screws
to install the closer body to the door and the
jamb shoe to the frame. Closer body should
be oriented so that the speed regulating valves
are toward the hinge stile of door.
Press pinion cap onto un-used closer body spindle.
See Adjustments on Page 6 for setting
Sweep Speed and Latch Speed.
NOTE:
Do not fully unscrew valves or hydraulic fluid will leak and
closer will no longer be functional.
Orient main arm so that the “1”, located on
the main arm, is on the same side of the
closer as the speed regulating valves. The
main arm will point out away from the door.
Screw connecting rod into forearm of main arm.
Rotate main arm until connecting rod is at a
90˚ angle to frame. While holding arm in this
position, tighten down forearm screw.
Speed regulating valves toward hinge edge.
5400 Series Non-Hold Open Door Closer - Regular Arm
Installation Instructions
2
HAGER COMPANIES
139 Victor Street, St. Louis, MO 63104 • (800) 325-9995 • Fax (800) 782-0149
A
5-1/2"
(140mm)
B
12"
(305mm)
A
4-1/16"
(103mm)
B
10-9/16"
(268mm)
For Opening to 120
For Opening 121 to 180
9-1/16"
(230 mm)
Dimensions apply to "all sizes".
2
3
1
4
