Top of
Frame
A
B
3/4"
(19mm)
1/2"
(13mm)
1-3/4"
(44mm)
1-3/4"
(44mm)
Fast
Slow
2
1
21
2
1
1. PARTS
3. INSTALL CLOSER
2. MARK AND DRILL HOLES (
Right Hand Shown)
4. INSTALL MAIN ARM
5. INSTALL MAIN ARM AND
CONNECTING ROD
6. ADJUSTMENTS
7. INSTALL PINION CAP
CONNECTING
ROD
MAIN ARM
PINION CAP
Select hand of door and the degree of door
opening. Separate template sections “A”
and “B”. Fold template on the corresponding
line for desired degree and hand. Match this
line with the hinge edge of door and attach
template to door. Be sure “Frame” line on
template lines up with the top edge of door.
Using a square, project “Closer Projection
Line” on section “A” of template onto frame
and use to align and attach section “B”.
Be sure to align bottom edge of section “B”
with edge of frame. Mark, prep and drill/tap
1/4"- 20 holes for connecting rod shoe and
closer body mounting screws.
Remove template and use mounting
screws to install the closer body to the
top jamb and the connecting rod shoe to
the door. Closer body should be oriented
so that the speed regulating valves are
toward the hinge stile of door.
A longer connecting
rod is required for
reveals greater than
3" (76mm)
Orient main arm so that the “4”, located on the main arm,
is on the same side of the closer as the speed regulating
valves. The main arm will point out away from the door.
Screw connecting rod into forearm
of main arm. Rotate main arm until
connecting rod is at a 90˚ angle to
frame. While holding arm in this
position, tighten down forearm screw.
Speed regulating valves toward hinge edge.
5400 Series Non-Hold Open Door Closer - Top Jamb Arm
Installation Instructions
5
HAGER COMPANIES
139 Victor Street, St. Louis, MO 63104 • (800) 325-9995 • Fax (800) 782-0149
Reveal
FRAME
WHEN ASSEMBLING TO SPINDLE
POSITION OF MAIN ARM
RIGHT HAND DOOR
Press pinion cap onto un-used closer body spindle.
See Adjustments on Page 6 for setting
Sweep Speed and Latch Speed.
NOTE:
Do not fully unscrew valves or hydraulic fluid will
leak and closer will no longer be functional.
MAIN ARM
90˚
RIGHT
ANGLE
A
5-5/8"
(143mm)
B
12-1/8"
(308mm)
A
3-7/16"
(87mm)
B
9-15/16"
(252mm)
For Opening to 120
For Opening 121 to 180
9-1/16"
(230 mm)
Dimensions apply to "all sizes".
2
3
1
4
