Hafele Free flap E, Manual

Page: 46 / 160

HDE
10/
201
7
1
2
.0
001.
010
.4
26.
0000
.00
732.
23.
027
46/160
Visual feedback
Every action is confirmed by flashing or illumination of the LEDs.
Operations
4.1 Teach in push button sender
» For step by step instructions, see picture section on page 152 , point 4.1.
» Repeat procedure for all push button senders that are assigned to the drive unit
(usually two push button senders).
» Continue to next menu item or complete setup, see section " 4.4 Complete
setup by carrying out an automatic reference run ".
4.2 Teaching in parallel operation (optional)
Cancel
The previous step has been cancelled.
Next menu item
The next menu item has been reached.
Warning
Warning signal in the event of a malfunction
or erroneous operation.
LED permanently on
LED flashing
LED permanently off
Green LED
Menu selec-
tion switch-
ing button
Long press > 2 s:
Setup start / Activate menu item
Extremely short press < 100 ms.
Next menu item
Red LED
NOTE
A push button sender can only be taught in at a drive.
After selecting the menu item, the push button sender must be pressed within
30 seconds. A successful teach-in is confirmed by an acoustic signal.
NOTE
The reference run must not be stopped or interrupted by intervening under any
circumstances.
NOTE
Only two drive units can ever be coordinated with each other simultaneously.
The procedure must be repeated for every other drive unit. A maximum of three
e-applications can be connected in series.
The respective menu items of both drive units must be called up within 30 seconds
for both drive units to be switched in parallel.