15/18
H
D
E
02
/2
015
73
2
.2
2.
2
70
ASSEMBLY HAS FINISHED
For proper use:
Check that the floor is clear to lower the bed.
Unlock to change from desk to bed position and lock again.
Stand at the middle of the furniture to pull from bed beam and push down the desk to make
the transformation.
The mechanism is already calibrated to work with the mattress on and a weight similar to
25 Kg on the desk.
Do not forget to place mattress for adequate functioning.
To open the bed and move the desk down, first unlock the desk then grab the front bed rail with
a hand and push down the desk with the other.To close the bed, unlock the locking device and
pull up the front bed rail. Always stand at the middle of the furniture to make the transformation
and grab the parts from its center.
It is important to lock the locking device after the transformation and before the use of the
desk or the bed.
The bed system is based on a desk/bed balance. Unbalanced system may result on having to
apply extra force when transforming from bed to desk and vice versa. Pin Arm position on arm
(A,B,C) helps to balance unbalanced system (less than 20Kg and more than 20Kg on desk,
less than 10 kg and more than 20kg on bed).
Side panels bear on the floor at the same level. A carpet can be placed beneath both sides
adjacent bearing sides, but do not place carpet or any shim beneath on side desk or body side
alone. Avoid excessive or too asymmetric loads on desk.
While lowering, please verify that bed bottom does not touch things left on the desk. Things left
on the desk cannot exceed 18 inches height. Next to the rear of the desk there is less height
available.
As with a door or a rocking chair, take good care not to trap fingers between closing parts.
If power or signal cables are to be installed, consult a qualified person.
If the bed does not stay down by itself, lock the locking device.
Ask your retailer for more details.
PROPER USE
Tavoletto_MA.fm Seite 15 Dienstag, 24. Februar 2015 2:40 14
