7
INSTALLATION
Drilling the Support surface and Fitting the Hood
SCREW FITTING
SNAP-ON FITTING
CLOSING ELEMENT
•
The hood support surface must be 220mm above
the bottom surface of the wall units.
•
Drill the support with a •
Ø
4,5 mm drill bit, using the
drilling template provided.
•
Cut a hole
Ø
150 mm in size on the support surface,
using the drilling template provided.
•
Fix using the 4 serews 12a (4,2 x 44,4) provided.
•
The hood can be installed either directly on the bottom
surface of the wall units using snap-on side supports.
•
Cut a fitted opening in the bottom surface of the wall
unit, as shown.
•
Insert the hood until the side supports snap into place.
•
Lock in position by tightening the screws Vf from un
-
derneath the hood.
•
The space between the edge of the hood and the rear
wall can be closed by applying the element 20 provid
-
ed, using the screws supplied for this purpose.
