Hafco TS250SC, Instructions Manual

Page: 7 / 28

4
Push stick
•
The push stick (P) (Figure 2) serves as an
extension of the hand and protects against
accidental contact with the saw blade.
•
Use push stick if the distance from the rip
fence to the saw blade is more than 120 mm.
Be sure the push stick be always at hand.
Figure 2
4. Special Product Features
•
Precisely adjustable bevel tilt from 0° through
45°
•
Steplessly adjustable depth of cut 0 – 80mm
•
All operating elements are located at the
machine’s front
•
An undervoltage relay prevents the machine
from starting up when power is restored after
a power failure
•
Standard mitre fence and rip fence
•
Extractable stop rail and end stop
•
Smooth sliding carriage with swing arm
support
•
Easy assembly and adjustment
5. Operating Elements
ON/OFF switch with emergency stop
•
To switch ON=depress upper green button (a)
(Figure 3)
•
To switch OFF=push upper red button (b)
(Figure 3) or on switch cover.
Note: Upon power failure an undervoltage
relay is activated. This prevents the starting of
the machine when the power is restored. To
restart the saw after a power failure the green
switch button (a) needs to be actuated again.
Figure 3
Handwheel for setting the depth of cut
•
The depth of cut can be adjusted by turning the
handwheel (c) (Figure 4)
Handwheel for blade tilt setting
•
With the handwheel (d) (Figure 5) the saw
blade can be steplessly tilted to the right from
0° (vertical) through 45°.
Rip fence
•
The rip fence slides on the saw table’s front
rail.
Figure 4
Figure 5