21
OPERATION MANUAL
TABLE LEVEL ADJUSTMENT
The out-feed and in-feed tables of the thicknesser
were set level before the machine left the factory.
However after shipping or prolong use the tables
may need to be adjusted.(Fig. 5.7)
To adjust the table:
1. DISCONNECT THE MACHINE FROM THE POWER
2. Place a straight edge across the tables.
3. If the table needs to be adjusted, loosen the
three screws “D” on the side of the table and
adjust as required.
4. Tighten the screws and recheck the level
F
ig
. 5.7
D
THICKNESS SCALE ADJUSTMENT
The scale, located on the right hand side of the thick-
nesser, shows the thickness of the finished work-
piece. (Fig. 5.8)
To make sure the scale is set correctly, run a piece
of timber through the thicknesser and measure the
finished size of the timber. If the measurment on the
scale is not the same as the timbers thickness, loos-
en the two round head screws (A) holding the scale
indicator (B) and adjust the thickness indicator to the
correct setting.
Make sure to re-tighten the two screws once the
adjustment is complete.
F
ig
. 5.8
A
B
