Hafco Woodmaster MJ2325D, Manual

Page: 14 / 33

21
Attaching the Saw Hood Guard
and the Extraction Hose...
There is no requirement to remove the guard. The profile of the riving knife precludes the
use of the saw for slotting or grooving, and the maximum depth of cut can be achieved with
the guard in place. The positioning of the extraction hose could be a nuisance if you are
cutting big boards, et al. In such a case it is better to remove the hosing from the guard,
than risk getting the workpiece snagged and perhaps 'slewing' on the saw.
Fig 21
Fig 22
Extraction
hose
Dust extraction
Hood guard Jubilee clip
Fitting the Small Mitre Fence...
Locate the small mitre fence. Introduce the
nose of the bar into the required slot in the
main table. Lay the bar flat and push forward.
The 'locking T' is produced by a washer
screwed to the underside of the bar, make
sure this engages in the 'T' slot in the table.
(See fig 23)
NOTE: With the rear extension table fitted it is
not possible to push the small mitre fence
completely 'through'. However, the travel is
such that the fence is able to travel well past
the cutting edge of the saw, and the rear of
the 'T' slot is open so that saw dust can be
pushed clear of the slot.
Fig 23
Riving knife