Hafco Metalmaster S829, Instruction & Parts Manual

Page: 7 / 31

6
The machine has been fixed on the stand already to use.
Giving the picture by appearing the foxing points for reference.

Align the four setscrews (G) on the underside of the machine
base to their corresponding holes in the stand.

Direct the setscrews (G) into their matching holes while
lowering the machine onto the stand.

Secure the machine onto the stand using three nuts to the
exposed setscrews.
The coolant tank platform has been fixed on already. The
following is for your reference.

Insert platform (H) to the interior of the machine stand.

Align the platform holes (i) to the screw holes (i) on the
interior of the machine stand.

Apply an M8x18x2, washer to each of the 2 M8x12 screws.

Secure the platform (H) to the stand.

Use a wrench to unscrew a M20 X 40 hex head screw (J)
from the oil fill hole (J).
Attach the control handle to the head assembly.

Insert the threaded end of the control handle into the gear oil
fill hole (J).

Turn the control handle (L) along the shaft to screw in the
control handle (L) until a tight fit.

Align the handle (L) so that the trigger switch (K) point up.
(Refer to image)
Connect the electric wire with the motor.

Locate the open socket (M) at the side of the electrical box on
the top of the motor.

Plug in the control handle cable into the open socket (M).

Use a wrench to screw in the cable connecter nut (N).
Attach the support roller to the left side of the base.

Place the support roller (P) up next to the machine base.

Align the 2 slots (O) in the base of the support roller with the
matching screw holes on the base of the machine.

Apply an M10 washer for each of 2 M10x25 hex head bolts.

Loosely screw the hex head bolts into the aligned slot (O) and
holes.

Adjust the height of the support roller (P). Place a level
across the mouth of the vise and support roller. If a long level
in not available, use a straight bar or piece of material then
place a small level on top. Raise or lower the support roller
until level.

Secure the support roller (P) into place. Use a wrench to
tighten down the 2 hex head bolts.
5
J
7
N
M
6
K
L
J
8
O
P
G G G G
4
H
i
3