Hafco Metalmaster S829, Instruction & Parts Manual, Page: 16 / 31

15
9.3 Loading the Work-piece

Use the vise hand-wheel to open the vise wider than the width of the work-piece.

Measure and mark off the length of material desired to be cut-off.

Place the work-piece on the flat surface in between the vise jaws.

Slide the work-piece across the vise so that the length mark lines up with the blade or disk.

Press the work-piece up against the back vise jaw.

Use the vise hand-wheel to clamp the work-piece.
If repetitive cuts are required for material of the same width:

Use the vise hand-wheel to approach the work-piece, but leave an approximate 5mm gap
between the mobile vise jaw and the work-piece.

Then use the vise lock lever to clamp and unclamp the work-piece.
Decrease vibration (workpiece position setting)
The clamping vise can be adjusted forward and backward to clamp work-piece for various
size.
Please be followed the trick as below when loading (setting) the work-piece position for
decreasing the vibration.
1. check the workpiece’s center not over the center of blade. Please see drew A
2.
9.4 Setting Cutting Length
Setting the cutting length removes the need to repeatedly measure work-pieces for repetitive cuts of a
single length.

Measure and mark off the length of material desired to be cut-
off.

Load the work-piece.

Line up the cut

Clamp the work-piece.

Loosen the hex nut at the base of the bar riser (A).

Slide the bar riser (A) along the long rod (C) so that the tip of
stop bar (B) touches the end of the work-piece.

Tighten the hex nut at the base of the bar riser (A).
The stop bar in use

Cut off the first length of work-piece.

Unclamp the work-piece

Slide the work-piece forward until it reaches tip of the stop bar (A).

Clamp the work-piece.

Then proceed with the operation cycle
9.5 Operation Cycle

Set the miter cut angle, if necessary

Open the vise, if necessary

Load the work-piece

Clamp the work-piece

Adjust the bar stop for cutting length, if necessary

Check that the main power light is ON (A).
A B C
H
E
C
D
A
B