14. Using these 2 screws and 1 bolt, fit the Belt Guard as shown.
15. Fit the Motor Pulley, making sure
the key is in place. Tighten the
grub screw.
16. Fit the driven pulley, making sure the grub screw lines up with the flat on
the shaft. Make sure both pulleys are the same distance from the Belt
Guard or the top faces of both Pulleys are level. Tighten the grub screw.
17. Fit the Drive Belt.
18.
IT IS STRONGLY ADVISED THAT ELECTRICAL WORK BE
UNDERTAKEN BY A FULLY LICENSED ELECTRICIAN.
Fit the Switch Box using the screws shown above.
19. Screw the 2 Earth wires to the Saw Body as shown above. The correct assembly sequence is; Split Washer
against head of Screw, Flat Washer, 2 Earth wires and lastly the Star Washer against the Saw Body.
AN ELECTRICIAN WILL THEN BE ABLE TO TEST THE MACHINE IS EARTHED CORRECTLY.
Plug the machine in and test the Stop Plate hits the Off Button just enough to switch off the machine without
putting too much pressure on the switch. Adjust as necessary.
BS4A (B002) Bandsaw Assembly Instructions
4/2/2014
Page 3 of 3
Pulley flush with shaft
Flat
Grub Screw
Earth Screw
WARNING!
Take care — the saw can be unstable whilst being moved on its wheels and the
saw Bow may flick up if the handle is lifted too far or the floor is uneven.
Only move the saw on its wheels on a level, flat concrete floor.
