MAINTENANCE
The mixer has been designed and manufactured in such a way that it does not need any particular
maintenance.
NEVER GREASE THE CROWN GEARS!!!!
Observe the
INSTRUCTIONS
on the control
of the operation of the mixer which are given in the
INSTRUCTIONS
on safety and operation, use and
storage. Make sure that the mixing drum is rotating slowly. Check that the screws are properly tightened.
REPAIRS
Always pull the plug before any repair work
Switch off the mixer by pulling the plug. Never switch on the mixer during any repair work. If it is necessary
to remove or switch off any safety devices, they must be remounted upon completion of the repair work.
Only the manufacturer or authorized technician may repair electrical parts. Use only original spare parts.
PROBLEM
MALFUNCTIONS
POSSIBLE CAUSE
REMEDY
No power. Defective cables. The
thermostat is not connected. The engine
is overloaded. The ventilation apertures
are obstructed or considerably reduced.
Foreign part in the conduct or mechanical
deformation of the conduct.
Check the fuse. Check the cable
(electrician).
Let the engine cool down. Check the
ventilation apertures (obstructed or
deformed).
The engine starts up
(hums) but the mixing
drum does not rotate.
The engine does
not start up.
The crown gear is blocked. The belt is not
tightened enough. The belt is broken. The
elastic pin on the small crown gear is
broken. The elastic pin on the pulley is
broken. Defective condenser.
Switch off the mixer. Pull the plug. Tighten
the pulley. Check the pin on the small
crown gear. Replace it, if necessary.
Remove the cap of the engine housing.
Check the belt and the pin of the pulley.
Replace them, if necessary. If the mixing
drum still does not rotate, call an expert
(defective condenser).
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
SPARE PARTS
01
01
02
01
01
01
01
02
01
01
Mixing drum
Small crown gear
Engine bearing
Eletrical engine
Engine housing
Pulley
Belt
Pin Ř6x40
Drume frame
Mixer frame
6006 (2RSR)
TEHNICAL DATA
11.
12.
13.
14.
15.
16.
17.
01
01
02
02
01
01
01
Support with leg
Suport for wheels
Wheel
Drum bearing
Lever set
Spring
Plastic handle ¨25 cm
6003 (2RSR)
5
GB
Engine
Type of the mixer
Protection Class
Type of protection
Theoretical volume of filling
Sound level (LPA)
Weight approximately:
Dimensions AxBxC (cm)
Article No.
Certificate :
P1=700W/S1=(6-25%)ED230V/50Hz/2,6A 2700 min-1
*P1=850W/S1=(6-25%)ED230V/50Hz/3,9A 2720min-1
125LS/LP 165LS/LP *190LS/LP
II II II
IP44 IP44 IP44
125L 150L 170L
75 dB(A) 75dB(A) 75dB(A)
58kg 58,5kg/65,5kg 61,5kg/68,5kg
114x72x134 122x79x135,5 122x79x143,5
106001/106002 106011/106012 106016/106017
RWTUW GS 03024 RWTUW GS 0324
6
Summary of Contents for ECM 125 CF
Page 8: ...F F 13 14 Haemmerlin Haemmerlin...
Page 9: ...15 F F 16...
Page 10: ...17 F 18...
Page 14: ...25 26 16 II 230 10 IEC245 4 1980 DIN 57 282 H07 RN F 3 1 5 25...