10
Application
Starting up and Operating
the Unit
Put down the handpiece in the
handpiece holder. Plug in the plug.
Turn on the unit with button 6. With
button 3 and 5 you can adjust the
speed level. Regularly the drill runs
clockwise. To change the direction,
push button 4. While the drill runs
with the left rotation the green LED
(no 2 in pic.1) is shining.
Clamping the bur/tool
The handpiece is equipped with a
chuck, which can hold all burs with
a diameter of 2,35 mm (this is the
diameter usually used for tools in
podiatry).
Keep the handpiece at spot A in
one hand. Turn the ring (spot B)
clockwise with your free hand until it
snaps. Now the chuck is opened.
Insert the bur until the end of the
chuck. Screw the ring B counter
clockwise until it snaps. Check, if
the bur sticks well.
It sticks well when you cannot pull it
out. Please do not turn on the unit
while the chuck is opened. This can
damage the motor and the
electronic devices.
For security reasons, only
change the tool if the
handpiece is turned off.
Setting up the Speed
Hold the handpiece (incl. tool) in
your hand or store it in the
handpiece holder attached to the
side of the control unit.
Switch on the unit with button (6).
Now you can also set the speed
with buttons (3) and (4). Choose the
direction of rotation with button (5).
In reverse running the LED (2) will
be on.
