USING YOUR KETTLE
If you are using the kettle for the first time, it is recommended that
you should clean your kettle before use by boiling the Max capacity of
water once and then discarding the water, repeat this step twice.
Wipe the surface with a damp cloth once cooled.
1. Place the kettle on the flat surface.
2. To fill the kettle, remove it from the power base and open the lid by
pulling on lid, once fill with the desired amount of water pop the lid
back on. The water level must be within the Min and the Max level.
Too little water will cause the kettle switching off before the water
has boiled.
NOTE: Do not fill the water over the maximum level, as water may spill
out of the spout when boiling. Ensure that the lid is firmly in place
before plugging the power outlet.
3. Position the kettle on the power base.
4. Connect the plug into a power outlet.
5. Once powered all 6 buttons will flash blue for 1 – 2 seconds.
6. To boil the kettle press the button. The default temperature is
100oC which will light up at the same time and the kettle will start
to boil.
To change temperature, select one of the other options 70 oC, 80 oC
or 90 oC after pressing the button. The kettle will then heat the
water to the selected temperature.
NOTE: Ensure that the lid is firmly closed during operation.
1. Lift the kettle from the power base and then pour the water.
NOTE: Be careful when pouring the water from your kettle as boiling
water may result in scalding, besides, don’t open the lid while the
water in the kettle is hot.
2. The kettle may be stored on the power base when not in use.
NOTE: Always disconnect the power supply when not in use
www.h
aden.com
www.hadenappliances.com
06
