18
5.52.180.00.01.07
12.4.2
Disassembly of the brake
Disassembly is performed in reverse order to the assembly.
12.4.3
Adjusting the air gap
View "X" on the brake.
1 Loosen the locking screws (6) by half a turn.
2 Turn the cap screws (8) into the magnetic body
(9) anti-clockwise.
3 By turning the locking screws (6) clockwise,
move the magnetic body (9) towards the
anchor plate (10) using a feeler gauge until
nominal air gap “a” is reached (see table).
4 Unscrew the cap screws (8) from the magnetic
body clockwise.
5 Tighten the locking screws (6).
6 Check the air gap again and re-adjust if
necessary.
Illustration 11
Pos: 16.5.1 /1_HADEF/12-INSTANDSETZUNG/Überlastsicherung/Allgemein/0 Überlastsicherungen - allgemein @ 0\mod_1173340101271_52.docx @ 546 @ @ 1
12.5 Overload
protection
If the hoist does not lift the permitted load, the overload protection must be adjusted. Adjustment may only be
done by a service company, authorised by the manufacturer!
DANGER!
The factory setting of the overload protection is secured by a seal. Any guarantee becomes invalid if this setting is
changed. Should maintenance be necessary, please contact a service company that is authorised by the
manufacturer.
Depending on the type of hoist, the following variants are possible:
Pos: 16.5.2 /1_HADEF/12-INSTANDSETZUNG/Überlastsicherung/Rutschkupplung/0 Kettenzug - Rutschkupplung @ 3\mod_1459331264433_52.docx @ 29942 @ @ 1
12.5.1 Slipping
clutch
Illustration 12
Pos: 16.5.3 /1_HADEF/12-INSTANDSETZUNG/Überlastsicherung/Mechanische Überlastsicherung/0 Kettenzug - mech. Federpaket @ 3\mod_1459331487894_52.docx @ 29948 @ @ 1
12.5.2
Mechanical spring assembly
In case of overload the load must be lowered until it reaches the ground so that the
spring assembly can release. Only thereafter it is possible to repeat the lifting motion.
Illustration 13
Illustration 14
Pos: 16.5.4 /1_HADEF/12-INSTANDSETZUNG/Überlastsicherung/Elektronisch/0 elektr. Hubkraftbegrenzung @ 3\mod_1459331574532_52.docx @ 29954 @ @ 1
12.5.3
Electronic hoisting power limiter
Power consumption of the hoist motor is measured during lifting movement of a load
by an adjustable power measuring device (overload guard). The setting is made via a
separate relay for main and creep lifting speed. Power consumption of the motor is
load-dependent and increases with the load. If the set value is exceeded, the relay
responds immediately and switches the motor off via switching elements. After the
overload protection has been activated the LOWER button must be pressed first so
that the LIFT function can be activated again. Before lifting again the load must be
reduced to the nominal load!
Illustration 15
Pos: 17.1 /1_HADEF/13-PRÜFUNG/*Ü1*/#. Kapitel - Prüfung @ 0\mod_1173264087196_52.docx @ 507 @ @ 1
