In the pilot's harness is space for the receiver and the receiver battery. The receiver may optionally also be installed inside the
lower part of the pilots body (recommended for Trike / engine backpack). In addition, the harness provides some room for
additional weight to adjust the flying speed of the respective wind speed and skill of the pilots. The open space is padded with
foam.
The RC system:
Connect the servos in the arms with a special hacker para mixer (optional) or directly to the RX, if your transmitter has an
appropriate mix function. Our Para-RC transmitter has this special mixer included. Make sure that the mixer is actually set to
active on the front switch board of the Para-RC transmitter. In the neutral position, the arms are in the top position. Move the
aileron stick to the right side, the pilot lowers the right arm (in flight direction). The left arm moves down when the aileron stick is
moved the left side. Pulling the "elevator stick" both arms will move down (Brake). This function controls the air speed and it is
typical for the landing (flare). If the servos do not run in the correct direction, change the two servo connectors on the receiver
and / or use the reverse function of your transmitter.
On the brake lines you make a mark with a pen, which marks the approximate location for the brake lines of implementation
through the top ring (IMPORTANT) of the C-Riser. This issue should be put on the brake line 34cm from the first knot in the
brake line. Depending on the neutral position of your RC system, the point still differs slightly from this mark. Some short tests
before flying the para-RC STUNT 3.0 show that the correct setting was found. Please see below.
Packing the Glider:
The canopy is flat on ground and the pilot doll is positioned at the trailing edge of the canopy. The risers with the lines running
on the right / left over at the pilot figure. In mild S-loops, the lines are laid loosely on the bottom surface of the canopy. Now it
works in each case the wing tip "Stabilo" one to the middle of the canopy and repeats this process until a strip about 20cm is
created. This is then folded three times and the canopy fits back into his knapsack. Recommendation: Separate the canopy not
from the pilot doll, so that the lines have not unpacked the next opportunities to devour / knotting.
