Page 28 of 38
Brushless DC Controller HST-70
Orginal
operating
manual
Rev1.2
Mounting and commissioning
4
Mounting and commissioning
4.1 Connection of phase and battery cables
You have to take care of the cabling between controller and motor as well as controller and battery yourself.
Make sure that the cross-sections are suitable for the power.
The phase and battery cables are to be fastened with M4 nuts (tightening torque 1.2Nm).
Attach suitable ring or tube cable lugs to the cables for this purpose.
NOTE
Unintentional loosening
To prevent unintentional loosening of the screw connection, select a suitable screw
locking device (spring washer, lock nut, etc.).
NOTE
Distance between cable lugs
Make sure that the cable lugs do not touch each other.
INFO
The cables should be kept as short as possible, especially between the controller
and the motor.
4.2 Sensor cable connection
Pin
Signal
Function
V
DC
1
Temp
Input (Analog)
5V
2
Enable
Input (Digital)
9-58,8 V
3
Power supply for hall
sensors
Output (Load)
5V
max. 50mA
4
Hall C
Input (Digital)
5V
5
Hall B
Input (Digital)
5V
6
Hall A
Input (Digital)
5V
7
PPM
Input (Digital)
5V
8
ADC
Input (Analog)
0-5V
9
CAN L
CAN Bus
<36V
10
CAN H
CAN Bus
<36V
11
GND ISO
GND ISO
0V
12
GND
GND
0V
Top view Molex MX120G
